Green Tractor Talk banner

1 - 2 of 2 Posts

·
Registered
Joined
·
144 Posts
Discussion Starter #1
I am mounting a rear discharge mower deck and need to figure out how to mount the enclosure kit. Didn't come with instructions. There is 4 eye nuts that are bolted on but no holes in the frame to put on. Same with the spring carriage bolts. If I need to drill 6 holes that is fine if i know where.

Sent from my SM-G950U using Tapatalk
 

·
Registered
Joined
·
144 Posts
Discussion Starter #2
I think I figured it out. There is a hole before the drive axle and ne higher and behind the axle. The spring hole was harder to confirm and I didn't use what jd had as a carriage bolt wouldn't work.

Found out the gear box mount is different in the switch. So I spend a couple hours rather then spend 130 to make the 60 side discharge work. Torch the pulley drive hole and drill the holder bolt holes and trim some.

After 3000 hours the pin to raise the deck in the cylinder was worn about through as are the lift chains and bolts. The belt tensio. Spring was also about worn through and the idler pulleys that can't be greased are not the best either. The deck wheels wear pretty loose and hard to remove the one I tried.

Totally worth putting this deck on. No more worrying about grass on the driveway. Or blowing out my siding. Or windrowing th grass into piles that prevents the grass from growing. Good to go for another 3000 hours. Fyi I bought used at about 2900 hours.

Sent from my SM-G950U using Tapatalk
 
1 - 2 of 2 Posts
Top