Green Tractor Talk banner
1 - 3 of 3 Posts

·
Premium Member
Early 2017 Vintage 1025R TLB (260/H120)
Joined
·
3,668 Posts
Flap
For a blade stop I use one of these.
But like others my impact gets it off while holding it. With gloves on if course
Not all of the blade is sharp! But I don't touch the blade(s) while the impact is Thwack-Thwack-Thwacking...
 
  • Like
Reactions: bpop

·
Premium Member
Early 2017 Vintage 1025R TLB (260/H120)
Joined
·
3,668 Posts
How do you guys use a torque wrench when you don’t use any blocks of wood?

I tried installing my blade bolts with the impact wrench on low as a test and the bolts were WAY over torqued.
I used my Dewalt 20v Impact Driver (no where near as strong as a proper impact wrench) and use the "good-n-tight" method of securing them. I usually swap my blades between 15-20 hours of mowing, likely way too much....
 

·
Premium Member
Early 2017 Vintage 1025R TLB (260/H120)
Joined
·
3,668 Posts
Ok. My only impact is the 1000lb/ft Milwaukee beast. I think the low setting is 250lbs. Still not nearly as familiar with it as you are with yours.
That's WAY too much muscle to put them on! 😁
 
  • Like
Reactions: bpop and Ritz
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top