Green Tractor Talk banner

1 - 1 of 1 Posts

·
Registered
Joined
·
84 Posts
Discussion Starter #1
I have looked at other people step install posting here on the forum. The biggest question was mmm clearance with the step. So, when I did mine today I put the 54" mmm on.

JD LVU18332 step
IMGP1728.JPG

I cut 3/4" off of the step top right at there it bends so it will be parallel to the ground.
IMGP1729.JPG

I used 1.5" 3/16 angle iron a foot long. I bolted this flush with the hydrualic filter bracket on the right and lower enough that there was @ 1/8" clearance from the bottom of the plastic floor lip.
IMGP1727.JPG
IMGP1730.JPG

I welded the step to the angle iron so it was just to the left of the hydrualic lines.
IMGP1731.JPG

With the step on i have a little over 2.5" between the step and 54" deck when raised all the way up.
IMGP1732.JPG
IMGP1733.JPG
view from top
IMGP1734.JPG

So far I am liking it. Way easier to get on.
 
1 - 1 of 1 Posts
Top