Green Tractor Talk banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2,245 Posts
Discussion Starter #1
So here’s the deal.

I am adding a second hydraulic circuit to my sons cub so he can use it to angle his snow blade and maybe some other project in the future.

I picked this valve up on evilpay. It meets the specs that I need. Open center etc.



I need to get the relief set at around 1000-1100 psi so it won’t damage the hydraulic system on he cub.

Does anyone have a setup that could make this easy to do?


Sent from my iPhone using Tapatalk Pro
 

·
Administrator
Joined
·
20,280 Posts
Sure. Deadhead the system. It’s not harmful if done in relatively short bursts. Simply push the joystick and hold it there until the cylinder stops. Once it stops, you’ll have your reading. :good2:
 
1 - 2 of 2 Posts
Top