Green Tractor Talk banner

1 - 4 of 4 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter #1
I just took the deck of my 2018 1025R in order to check the underside of the deck and lube the arbors on the deck. I have 31 hours on the machine. After disconnecting the deck I got under the machine and noticed that the bearing in the auto connect mechanism had slid out of the housing . The bearing and the coupler appear to be undamaged but I am a little concerned. Has anyone else had this problem?

Looks like this bering should be retained in the housing by some means.

Thanks
Sharkyj
 

·
Registered
Joined
·
913 Posts

·
Registered
Joined
·
913 Posts
There should be a snap ring holding in the bearing.
Yep, I forgot about the snap ring. Both the snap ring and the washer were missing when the support bearing for my MMM PTO shaft spit out its bearing.:banghead:
 
1 - 4 of 4 Posts
Top