Green Tractor Talk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
60 Posts
Might I interject another question...the little plastic square push nuts that the screws thread into....anyone find a good alternative, replacement, or different way of doing it? I've used Chrysler license plate nuts as replacements in the past. However, the front two (Deere or otherwise) always pop out.

Sent from my SM-G781V using Tapatalk
 

·
Registered
Joined
·
60 Posts
Ace is where I got them too. They work, but the front two that also hold onto the lower firewall (on the 332 at least) end up popping out of the square hole in the frame as soon as I ride around the yard.

Sent from my SM-G781V using Tapatalk
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top