So after deciding I wanted to separate the MMM from the 3 point hitch I purchased the BLV10933. I'm relatively new to tractors but really frustrated with the install, first the instructions are clear like mud.
After removing both rear tires and fenders, not a joy, I was able to get started with the install. The illustrations are vague and show very small selected areas that don't give a lot of help in the process, my TLB from the factory had the power beyond installed and had none of the apparently required special hoses for the install, I will be ordering them Monday and leaving the tractor disassembled until I get them.
At this point i have the vale body in placa, the lines that seem to connect attached, but I have been searching for the electrical connectors at the main chassis harness, the illustration shows the in an area near the muffler I think, the jumpoer harnesses in the kit do not match any of the 5 different connectors I found tied back in that general area.
Does anyone here know where these connectors might be ?
Could the kit I have have the wrong jumper harnesses in it ?
I've got about 6 hours into this project and am pretty frustrated.
The purchase from our local United AG and Turf dealer left me very frustrated and unwilling to go there. Is this how this ownership my experience is going to be ?
Thanks for any help you could provide.
After removing both rear tires and fenders, not a joy, I was able to get started with the install. The illustrations are vague and show very small selected areas that don't give a lot of help in the process, my TLB from the factory had the power beyond installed and had none of the apparently required special hoses for the install, I will be ordering them Monday and leaving the tractor disassembled until I get them.
At this point i have the vale body in placa, the lines that seem to connect attached, but I have been searching for the electrical connectors at the main chassis harness, the illustration shows the in an area near the muffler I think, the jumpoer harnesses in the kit do not match any of the 5 different connectors I found tied back in that general area.
Does anyone here know where these connectors might be ?
Could the kit I have have the wrong jumper harnesses in it ?
I've got about 6 hours into this project and am pretty frustrated.
The purchase from our local United AG and Turf dealer left me very frustrated and unwilling to go there. Is this how this ownership my experience is going to be ?
Thanks for any help you could provide.
