Green Tractor Talk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
I noticed today that my bolt to the injection pump coming from the fuel filter is dripping. Can I just tighten it or does it have a certain torque. I looked all through my technical manual and couldn't find anything about it. I believe that the part number on it is M801108.
793479
Automotive tire Light Automotive lighting Motor vehicle Automotive fuel system
 

·
Chief Stick-picker-upper
Joined
·
19,535 Posts
There are two special washers on each side of the “Banjo” fitting. I don’t have the torque specs, but I wouldn’t apply any more than 35 ft. lb. to it.
Back it off a bit, then tighten it.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top