Green Tractor Talk banner

Boltonhooks can you help me grease a driveshaft?

4186 Views 38 Replies 29 Participants Last post by  chex313
Kenny, how much money will it take for you to build us a grease fitting that will do the drive shaft on the 1025r? I’m ready to go to Deere HQ and demand that the engineers involved come out and grease it on the front lawn.
1 - 1 of 1 Posts
Not on the newer ones, one piece

rob
There is another solution. Take off the lower kick panel under the dash, this allows access to the fitting from the top side with no little hole to line up. The only downside is that it is a bit of a process to get that panel off.


Mr. Moose
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top