[trav]

Kenny, how much money will it take for you to build us a grease fitting that will do the drive shaft on the 1025r? I’m ready to go to Deere HQ and demand that the engineers involved come out and grease it on the front lawn.

Is it harder than on the 2025 gen 2? Mine wasn't difficult at all, I lined it up with the hole and used a standard tip on a pistol grip grease gun (manual gun). It only took a few minutes to do.

 

[trav]

The grease zerk is not straight on to the access hole on my 2018 1025r, it’s an impossible angle

Well that would make it difficult. 🤔