Green Tractor Talk banner
1 - 3 of 3 Posts

·
Registered
Joined
·
698 Posts
Discussion Starter · #1 ·
I am adding some lights to my 2038R and would like to not cut the stock wiring. I attempted to get a 14-16 bullet connector from amazon but the male bullet connector does not seat into the stock female connector. I tried 18-20 connector to and no luck. The shape of the bullet is just not the same as the stock one.

Anyone know of a good source that works?
 

·
Super Moderator
Joined
·
6,933 Posts
You might ant to read through this thread:

 
  • Like
Reactions: Hagak

·
Registered
Joined
·
54 Posts
You’ll need something like this:

I bought a shorter one at Tractor supply, but if I were doing it over I’d get one with longer wire. You could cut this in half and have more than enough wire to make it to the top of the ROPS.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top