I asked around and came on here researching and I went with a 4' bush hog for my 1023e
.I used it down at camp a couple weeks ago and it did outstanding with no real loss of power even up hills. Look up my thread from a couple weeks ago for some pics I took after using my 4' hog. You will need front ballast if you didn't already know.
Let us know what you go with.:good2:
Afer reading about ounting rear view mirrors in the ttop hole in the loader vertical arm, I ordered one and mounted it. The reflection from the side flood at night just does not get it. I have seen the mirrors mounted on extensions. i would appreciate it if I got some input on extending the...
I have been noticing hydraulic oil stains within the tread of my right rear tire on my 1025R. They are coming from the Main control valve (MCV loader joystick). Three weeks ago I removed the right rear fender to gain access to the MCV fittings. All fittings appeared to be tight with no fluid...
the adjustable stop latch/lever or whatever does not stay in place because of the flimsy plastic that it is mounted to. consequently, my rake drops deeper than i want it to. is there a home made fix for this???
I have a rear blower attached to my 3 point hitch and I noticed lately that it is not rising up level.
The right side goes higher than the left which put the blower at an angle in the air.
I removed the two arms and tested the lift. They both seem to be lifting the same.