Green Tractor Talk banner
1 - 3 of 3 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
Got my 1025r this past spring with a mid-mount mower drive over deck and a FEL. Planning on getting a 3pt tiller and rake this spring. The lift for the mid and rear pto implements is on the same control. So when I take off the mid mount deck then lower the pto as I would for the tiller or rake, the drive shaft for the mower will also lower. Will this not be a problem? Will I not the drive shaft possible get caught up and or damaged when in a lowered position? How do you all deal with this?
 

·
Registered
Joined
·
3,383 Posts
After you have removed the mmm, raise the three point control fully and use the cutting height adjusting knob to set to the lock position. This will allow full range of three point motion without allowing the mmm arms to move below full raised position.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top