Green Tractor Talk banner

Dual cylinder rack for my MM 210 Welder

10507 Views 43 Replies 9 Participants Last post by  mjncad
I recently bought a used spoolgun to try my hand at welding AL and needed to buy a tank of Argon, but my welder would not hold the second tank. Miller sells a kit-but it's about $200 and widens the stance of the welder quite a bit so I started making this. Still need to build the top support rack, but the bottom is done except for paint.
1 - 1 of 44 Posts
Good job Kennyd. What type of plasma cutter do you have?
1 - 1 of 44 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.