Green Tractor Talk banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
4,434 Posts
Discussion Starter #1
hello all,

i am in need of a good 54 or 60 inch bush hog, preferably a john deere/frontier model, such as an RC10x or RC20x. must be in good condition with minimal rust and gearbox must hold oil.

need a new one because the pto broke and got bent on the current one. the mower is older so knowone has the right replacement part. the cost of a new shaft is the same as a new used mower. also, i noticed i bunch of rust holes in the top on the deck.

thanks!!!

-jh
 

·
Administrator
Joined
·
18,274 Posts
Can you post a picture of the broken parts please?
 

·
Registered
Joined
·
4,434 Posts
Discussion Starter #3
i would, but the friggin computer gives me an error message.
 

·
Registered
Joined
·
4,434 Posts
Discussion Starter #4 (Edited)
ok, so the reason i started this thread is because the shaft is an older Italian made model and parts are scarce. the bushhog is older as well and so why spend 200 $ on a new shaft from tsc when the life of the cutter is not known? so, finally found a new yoke allllllll the way up in Indianapolis. they cut off the old one and pinned on a new one. cut a bunch of trails today thru thick weeds and it preformed flawlessly. so i guess ya'll cane close this one up.

thanks guys!
 
  • Like
Reactions: Kennyd
1 - 4 of 4 Posts
Status
Not open for further replies.
Top