Green Tractor Talk banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,313 Posts
Discussion Starter #1
A couple days ago when I went to grease the loader I discovered one of the fittings was so loose it was just about to fall out. Another was loose enough to turn with fingers. So when I tightened them back up I checked the others. Out of the twelve zerks on my H120 only three were tight.
 

·
Registered
Joined
·
377 Posts
Last year, a few of mine were loose as well.
 

·
Registered
Joined
·
709 Posts
That is a common problem on a lot of parts and equipment with grease fittings not just John Deere. That and they were over tightened and cracked or broke so they fall off the first time you connect a grease gun to them, if they lasted until then.
 
1 - 3 of 3 Posts
Top