Green Tractor Talk banner
1 - 7 of 7 Posts

·
Registered
Joined
·
31 Posts
Discussion Starter · #1 ·
I Have my 47 in quick attach snowblower all installed on my 2021 1025r. I can’t get the harness and sensor that overrides the safety switch to work right. It shuts down the motor if the mid pto is turning and I go in reverse. I plugged it in to the 3 wire plug that was on the left side of the tractor. The plug was right in front of the starter. Green, red, black wires in the plug. I installed the sensor on the bracket in between the bearings, pointing at the silver part of the pto shaft. What am I doing wrong?
 

Attachments

·
Super Moderator
Joined
·
6,281 Posts
Did you adjust the sensor gap?
 

·
Registered
Joined
·
31 Posts
Discussion Starter · #3 ·
Can you explain how to adjust it? It didn’t seem to have any adjustment to the mount.
 

·
Registered
Joined
·
353 Posts
Adjusting the front pto shaft sensor with JD gauge on x758...
Hood Automotive lighting Automotive tire Grille Motor vehicle
Hood Automotive tire Gesture Finger Motor vehicle
 
  • Like
Reactions: kylew

·
Registered
Joined
·
31 Posts
Discussion Starter · #7 ·
Just an update. Adjusting the sensor bracket closer fixed the problem. I hade to loosen the 2 bolts and squeeze the bracket to hold it. Then tighten the bolts back up. Otherwise it would walk back. Worked great! Thanks for the help!
 
1 - 7 of 7 Posts
Top