[GeoffP]

I purchased the TL5500 high/low beam LED headlights from Tiger lights for my JD5500 but when I connect them, only the low beam setting works. I tried reconnecting them a few times in case the connection was bad but no change. I unplugged them and put the old ones back in and the high beam works fine. Any suggestions?

 

[Guja0501]

Is it the type of plug where it can still go in rotated 180 degrees?

 

[GeoffP]

No, but good thought. The plug and adaptor can only go in one way.

 

[hosspuller]

Apply 12 volts to the connector of the lights to confirm the LED high beam actually works.
Some lights require both the hi & lo beams to be powered for hi beams.

 

[GeoffP]

Apply 12 volts to the connector of the lights to confirm the LED high beam actually works.
Some lights require both the hi & lo beams to be powered for hi beams.

Thanks. I applied the 12V directly to the 3pin plug for the new lights and I can see that both the high and low are working when I switch the power from one pin to the other. We are now narrowed down to diagnosing the issue with the adapter from the 9004 3 pin bulb plug on the tractor to the 3pin plug of the new LED bulbs.

 

[workinonit]

Did you verify that you are losing your 12 volts through the connector? With a meter? There may be a pin that pushed out. on that connector.