I have not been following this form and have not been able to locate the thread where it says how to do this. I know this has probably been discussed many times. And I know back in the day you could just stick a wire in it and that would bypass it. But the last time I tried to do this (I think it was on a 800 series) Deere had more than two wires on it and I had to screw the bottom of the seat together to engage the switch. If someone should point me to the thread I would appreciate it. And I'm really not looking for the gloom and doomers to tell me your opinions on how unsafe this is. But If you have a good story though of how you cut your foot off or something due to disabling the safety seat switch. I would like to hear it so I could try to avoid doing the same thing. Thanks for the help.