Green Tractor Talk banner
1 - 7 of 7 Posts

·
Registered
Joined
·
944 Posts
Discussion Starter · #1 ·
What size hose is needed to connect the backhoe power and return ports on a 1025r to a rear valve? Can it be sized down to 3/8", or maybe even 1/4"?
 

·
Registered
Joined
·
944 Posts
Discussion Starter · #3 ·
No smaller than 3/8 for PB lines.
Would 1/2" be the wiser choice? I'll be adding a single spool valve for a hydraulic top link.
 

·
Registered
Joined
·
944 Posts
Discussion Starter · #5 ·

·
Registered
Joined
·
944 Posts
Discussion Starter · #6 ·
Your are only flowing ~4 GPM, 3/8" is fine.
So, I'm thinking 3/8 for PG and 1/4 for the work lines to the hydraulic top link should work well.
 

·
Administrator
Joined
·
22,385 Posts
  • Like
Reactions: KeyboardJungle
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top