[jd4230]

Does anyone know where I could purchase hydraulic restrictors with o-ring boss style fittings? I need SAE #8 or 3/4-16 style fittings. I can find NPT style but ORB fittings are much cleaner and that’s what I have on all my hydraulic hoses.

 

[MarkEagleUSA]

#1 and #15

https://partscatalog.deere.com/jdrc/sidebyside/equipment/514202/referrer/navigation/pgId/425321740

 

[MarkEagleUSA]

#1 and #15

https://partscatalog.deere.com/jdrc/sidebyside/equipment/514202/referrer/navigation/pgId/425321740

Sorry, those are likely 1/4"...

 

[Kennyd]

Good luck! LOL
You can make a "washer" style like these and install between two joints:


TeeJet Stainless Steel Flow Regulator Orifice Plate | CP4916-51

 

[Tx Jim]

I agree with Kenny. A coin such as penny with a hole drilled in it will serve as a restrictor but one might have to remove part of threaded area for 0-ring to seal.

 

[jd4230]

This is what I found. I remembered that I put single point hook up for my loader. It came with an orifice restrictor. So I pulled the one off of my old hoses from my loader and installed it on my hydraulic third link. It worked! It’s a SAE #6 size. I found that Brand hydraulics had the same thing in #8 size plus you can pick whatever orifice size you want.