Hi , I’m new to the fourm and have a question about my 2032R hydraulics on the front end loader. I was stacking up snow and the loader got stuck in full up position and would not go down it bogged down when trying . The tilt back and forth worked fine . I did a search on here and it recommended swapping hoses to see if it did it with the tilt function. When I disconnected the hose the loader stayed in the raised position with the hose removed. The hose was pressured up so I carefully relived the pressure . As I bled off the pressure the loader lowered all the way to the ground. I reconnected the hose and it would raise ok but bogs down when lowering like it up against the relief valve. The hose that I unhooked has what I’m thinking may be a check valve on it . Could this be the problem. Any replies are appreciated
KCAlaska
Joined
·
1 Posts
I just encountered the same issue. Loader wouldn't lower. I got it down and tried everything that was said here. It worked (in reverse) when I switched the lines so I tried to finish what I was doing, then it completely locked up! No lift or lower! Switched the lines back to normal and it went back to having lift again but couldn't lower it. I saw the post about possibly being a bad female connector but why would both fail when I switched/reversed the lines? Any ideas?
Oh yeah there's no issues with the bucket controls.
Oh yeah there's no issues with the bucket controls.
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
