Green Tractor Talk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2,356 Posts
PTO coil may be getting bad. Disconnect plug at pto and ohm pto windings. A good coil should be around 3.5 -4+ ohms, 3 ohms is barely marginal, and 2.5 ohms is shot! The lower ohms allows more amps to flow and tends to blow fuses, heat connections (overheat & melt plastic housing), etc.! Ohm windings and report back. Bob
 

·
Registered
Joined
·
2,356 Posts
aj, If you feel adventurous, hang onto your old clutch! Do an online search or search this Forum for rewinding the clutch. I won't say it's easy or difficult as this is something you'll have to determine after reading the info!

Also, do some searches for a replacement clutch... JD clutches are pricey! I don't know the names of of the top of my head, but others have used them and are happy with the results AND the cost savings! Bob
 
  • Like
Reactions: ajc6514
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top