Green Tractor Talk banner

1 - 2 of 2 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
Does anyone own the newest version of the imatch along with a 48" frontier box blade? I am trying to figure out the proper setup on this to make imatch work well with it. So far the only way it's functioning properly is if one bolt is removed from the hook on the imatch to allow the hook to swing outwards when coming up underneath the top link of the box blade. If the hook is not allowed to do so, both the upper link housing of the match and the upper link housing of the box blade touch eachother before the hook can get under.
 

·
Super Moderator
Joined
·
5,632 Posts
I don't have the Frontier,but I think they will all be the same when it comes to lining them up with the I-Match. I have a Woods GB65,and I've found the box has to be angled/tilted slightly so the 3PT end is just sitting downward a bit. I put a couple 2x4's under the sides close to the cutting edges and that does the trick.
Hope this info helps you out. I'd post a pic but I don't have one.......sorry.

Greg
 
1 - 2 of 2 Posts
Top