[Ron_]

I recently bought a 8310 & am having trouble getting the IMS to raise/lower the implement (SCV). I can program it to shift gears, doing it just lke the manual says. What could be wrong?

 

[dieselshadow]

Welcome to GTT!

:wgtt:

Ron, you've found and joined a great forum!:thumbup1gif: I can't help you directly with your problem, but I sure someone who can will be along before too long.:good2:

 

[Ron_]

Thanks, I hope so.

 

[Brian]

Can you take pictures of your dash? I have an 8300 and have had issues with the three point, mostly due to water getting into the hydraulic cylinders since they are upside down.

Sent from my DROID RAZR using Tapatalk

 

[Ron_]

Now with pictures!

Update.... photos

 

[jd110]

Ron, I am assuming that the scv's are working normally when worked normally? If so, then the only solution I can find is that there is a 30 second time limit to program your functions into IMS system. Are you entering multiple functions and scv is last in sequence? If you are programming within 30 seconds and you are not getting error codes, then I would suspect software problem. You may need to replace the controller. 10 series controllers were not reprogrammable.