Green Tractor Talk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
136 Posts
Discussion Starter · #1 ·
I'm considering installing the Independent Lift System (LVB25605) on my 2720 to control the height of my 62D MMM. While the mechanical lift works okay, the highest I can raise the deck only provides a 3 1/4 inch high cut (I'd like 4 inches for the drier parts of Summer).

Does the ILS provide allow for a higher cut? I imagine both are limited by the up-stop block.


Sent from my SM-T560NU using Tapatalk
 

·
Registered
Joined
·
136 Posts
Discussion Starter · #5 ·
Have you checked that the linkage that raises the deck is correct?
I could probably tighten the linkages to gain another 1/2 inch, but I'm concerned about placing too much strain on the draft arms (I've had problems with the factory welds breaking). My current settings have the deck level side-to-side and front-to-back.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top