Green Tractor Talk banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 · (Edited)
I have a weird thing happening with my front blade and it only happens when I take the blade out of float mode. The lever will be locked forward and the blade is in float and straight. Then when I pull back on the lever to raise the plow blade, the blade will angle fully right and then go down so I am stuck with my front wheels up in the air. Usually I can fenagle the bottom lever and get the tractor to back down, but last night this happened and I couldnt get the lever to release for a good 5 minutes.

I did find that if I am quick to engage either level as soon as this "lock out" starts then I can stop it from happening, but I need to be super quick. One thing to note is that the bottom lever was stuck when I first attached the blade so I had to free it up, same as I have read other users doing.

Anyone have a suggestion of how I can stop the blade from doing this when I take it out of float?? Has this happened to anyone else? I have searched forums and can't find it as a known issue.

This may be posted to the wrong location in the forum but I'll give it a shot here first. ?
 

·
Premium Member
Joined
·
13,024 Posts
Make sure to check the other location in the Garden Tractors as you are getting responses to this same post in that thread,.
 

·
Administrator
Joined
·
21,040 Posts
I closed this thread since its a duplicate.

 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top