Green Tractor Talk banner
1 - 4 of 4 Posts

·
Registered
Joined
·
106 Posts
Discussion Starter · #1 ·
JD 54" QH Snowblower

01 - 54" QH snowblower
02 - spout cable
03 - hydraulics
04 - snowblower drive shaft

Snowblower removal

05 - remove spout cable
06 - coil spout cable around chute
07 - disconnect chute rotation hydraulics and coil around chute
08 - leave QH hydraulics connected
09 - disconnect snowblower driveshaft and place on support rod
10 - unlock front hitch levers
11 - use a dolly for easy snowblower storage moving

Quick Hitch Removal

12 - lift QH and slide dolly under snowblower
13 - lower QH and back away. Use dolly to move snowblower.
14 - raise QH
15 - disconnect QH hydraulics and coil for storage, unlock levers, lift and remove QH
 

Attachments

·
Registered
Joined
·
106 Posts
Discussion Starter · #2 ·
Front PTO driveshaft and front hitch removal

16 - disconnect front PTO driveshaft at mid pto. Pull back on colar to release. Move forward to clear mid pto.
17 - move driveshaft rearward to pull out of front pto bearings

Front PTO hitch removal

18 - to remove front pto hitch
19 - pull out retainer rod and lift out hitch assembly

Final Steps

20 - Almost done. Now service and grease all components removed so they are ready to go next time.
 

Attachments

·
Administrator
Joined
·
21,063 Posts
Wow, great post Darrell:dance:
 

·
Premium Member
Joined
·
6,698 Posts
Excellent post! :good2::thumbup1gif:

Very detailed and good explanations. That is a nice dolly you have to move the blower around on. Those things are handy.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top