Green Tractor Talk banner
1 - 7 of 7 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I have a 350B crawler loader and a 9300 backhoe. I connected the backhoe supply line to the power beyond port from the loader control valve. The backhoe sort of works but the boom will barely lift and the outriggers are weak and won't lift the dozer. Plenty of power to the loader. I have since learned I should have installed a power beyond sleeve. I can not find one so far from Nortrax.

Can anyone tell me if I am heading down the right road and if so, Where I might find the sleeve?

TIA
 

·
Administrator
Joined
·
20,876 Posts
Welcome,
I am not familiar at all with this equipment, but are both system open or closed center? You mentioned "power beyond" so that suggest open center hydraulics, but I would think the dozer would have a closed center system on it.
 

·
Registered
Joined
·
2,767 Posts
Welcome to GTT
My knowledge of JD industrial hyd systems is also very limited. Do you have BH hyd's attached to crawler similar to photo? There is a serial # break at 016386-

785155
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #5 ·
Yes, That is how I have it connected. In that diagram, I need the #16 sleeve and seals. Do you have the part # for that?

Where could I access that diagram?

Thanks
 
1 - 7 of 7 Posts
Top