Green Tractor Talk banner

1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hey guys, like the title says I have a 2004 John Deere 4110. Machine has only 350 hours on it. Since new it has had a FEL and a 46 backhoe on the back. I recently decided to put a 3 point setup on it to use some rear implements as well. I installed the 3 point setup and as soon as I put an implement on the 3 point I get a really bad non stop bounce on the implement. Adjusting the hydraulic control valve by the Floor board does nothing to stop this nor does it stop the implement from dropping after the tractor is shut off. I’ve been doing a bit of research today and thinking maybe rockshaft valve? Has anyone ever had this problem?

Thanks
Bryan
 

·
Premium Member
Joined
·
10,669 Posts
Does it only do it when the 3PH is raised all the way up or will it also bounce if you only raise the implement 1/2 way up?
 

·
Premium Member
Joined
·
10,669 Posts
It will do it 1/2 way up too.
Darn, I was thinking it may just be a feedback adjustment but that only controls how it reacts when fully raised.
 
1 - 4 of 4 Posts
Top