Green Tractor Talk banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I have a JD 425,it ran fine all last year and upon using this year it started up and runs great until I release the parking brake then it dies ,I checked the seat switch and the parking brake switch both seem fine, I did notice the ignition module board connectors seemed corroded and 2 wires looked as if they got hot at one time probably due to corrosion ,I noticed when moving the brake the red and green lights on module flicker. I am wondering if the board could be bad?Bad ground? I did notice a few times last summer when I engaged PTO switch it did not engage immediately I had to operate switch a few times, any ideas?Thanks
 

·
Registered
Joined
·
1,751 Posts
The switches "seem" fine? Did you check for power to switch and out of switch?. Start there.

Sent from my LGL52VL using Tapatalk
 
1 - 3 of 3 Posts
Top