Green Tractor Talk banner

1 - 7 of 7 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I have a 2003 Model JD L110 Lawn Tractor.
Due to some hungry mice, and then my dogs trying to get to said mice, I am in the process of complete rewiring.
I have installed both wiring harnesses, front and rear, as well as a new solenoid and ignition switch.

My questions involve some wires from the Kohler 17.5 Engine.

1) There are three wires attached to the voltage regulator (in picture) the two white ones go to the stator and are fine.
The middle wire, the black one was chewed/pulled off from the regulator - the Question - Where does this wire go?

2) Just in front of the throttle linkage, there are two wires coming out of engine, a white one and a red one. (also visible in picture)
Again not attached at the other end. Where do these two wires go?
 

Attachments

·
Registered
Joined
·
3 Posts
Discussion Starter #4
I am doing a repower of a LX with a Kohler from a L110.
White is kill wire to coil.
Red is fuel shutoff on carb.
Black is charging wire.
Thank you, but what where do the bare end of these three wires attach?
Do you have pictures perhaps?
 

·
Registered
Joined
·
112 Posts
No real picture all my wiring is done. I am using the JD VR and plug in from the Kaw. I have eliminated the Kohler VR. Aka the black wire.
 
1 - 7 of 7 Posts
Top