Green Tractor Talk banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have just replaced the drive belt on my JD and the belt has no tension at all when the tractor is off. I have replaced belst a few times and each time there was tension on the belt. As an example previously when I would turn the blades by hand I could move one blade with no problem but to move the second blade I had to hold onto the pulley to prevent the first balde from moving.

I have triple checked the belt routing and that is fine. I adjusted the brakes thinking this would tighten arm holding one of the pulleys but this didnt work.

Any ideas?
 

·
GTT's Pilot in Command (PIC)
Joined
·
8,558 Posts
I have no answer for your question, but wanted to say...

:wgtt:
 
1 - 2 of 2 Posts
Top