Green Tractor Talk banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hi folks, new here. I am installing a 541 nsl loader on a 5520 tractor. There are four figure eight spacers that go between the brackets and the tractor. Are any washers used with the spacers? The online manual shows 1 washer one each bolt head, but I seem to have a huge amount of washers in the kit. I am removing the paint and will torque the bolts. Any ideas?
 

·
Administrator
Joined
·
20,969 Posts
I'm not an expert, I just looked it up on JD parts. Here's what I found.

WP6712_________UN23JUL07.jpg

Hopefully that helps.:good2:
 

·
Administrator
Joined
·
18,466 Posts
:wgtt:


Sometimes you do get extra hardware in the kit(s) since they can be used for different applications. With the manual and the pic Jason posted you should be all set.
 

·
Registered
Joined
·
2 Posts
Discussion Starter #4
Thanks guys. I have the same info Jason is showing. I guess the best thing I can do is make sure the loader arms line up before I torque the bolts. Thanks again
 
1 - 4 of 4 Posts
Top