Green Tractor Talk banner

LT133 Hood Repair

1128 Views 3 Replies 3 Participants Last post by  Gizmo2
I have a new front bumper "fender" ordered. However the front corner of the hood where the bushing goes and is the pivot point has the "stem" where the screw goes through the bushing is snapped off the hood. I am thinking about drilling a hole through the hood and using a longer bolt to act as a pivot point. Has anyone run into this or have another idea. I can not attach a picture at this time.
1 - 4 of 4 Posts
Not for a LT133, but I did that type of repair for a vintage LX172.
See this thread: What did you do on or to your John Deere GT today
Post # 2594
  • Like
Reactions: 1
That is what I may do if my idea does not work thanks for the picture
  • Like
Reactions: 1
I think it was Old Cajun, that recommended it.
Cracked GT235 hood, JB weld, holding well...
Green Plant Motor vehicle Fender Wood
See less See more
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.