Green Tractor Talk banner
1 - 1 of 1 Posts

·
Registered
JD 455, 4610, 4052R, and 6120E
Joined
·
688 Posts
Discussion Starter · #1 ·
I always have a fair amount of steel angle, tubing, and pipe and some dimensional lumber on hand to use in fabricating whatever project comes up. I am always looking for good deals on steel on C.L. and generally acquire it at significantly lower than retail pricing.

Having this inventory means I needed some way to store it. I realized that I could fabricate these simple brackets for attaching to the 6x6 posts in my equipment shed. They are easy to move around if my needs change.

795879


Each bracket is made out of an 18" piece of 1.5" square tubing and two 4" pieces of angle iron (pretty much any size available). The angle iron pieces are welded to the tubing. They are attached to the post with either wood screws or lag bolts depending on the expected load.

795873
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top