Green Tractor Talk banner
1 - 4 of 4 Posts

·
Registered
Joined
·
176 Posts
Discussion Starter · #1 ·
Pop quiz!

Who knows the correct size bolts and square nuts needed to remove the clutch driving disc. I can't remember for the life of me what size or what I did with the ones I had. Will be going into town tomorrow and can get a new set then.

Thanks in advance everyone.
 
  • Like
Reactions: theduke

·
Registered
Joined
·
722 Posts
1/2 inch IIRC.

Green Automotive tire Motor vehicle Machine tool Gas


If I was at home I'd look in a manual but I'm not. This pic is one of my 70 D, no square nut needed. Will try to find a pic of my 60.

Automotive tire Motor vehicle Vehicle brake Bumper Rim
Wood Tool Office ruler Font Hardwood


This is a 60 and I used this puller.

Wheel Tire Automotive tire Motor vehicle Bicycle part


I could could tell some stories about this tractor ........................................ maybe another time.
 

·
Registered
Joined
·
176 Posts
Discussion Starter · #3 ·
For some reason I want to say 1/2 is not big enough, but I think I will start there and get a size or two larger.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top