Green Tractor Talk banner

1 - 7 of 7 Posts

·
Registered
Joined
·
1,058 Posts
Discussion Starter #1

·
Registered
Joined
·
3,873 Posts
What is the height difference before and after when mounted on the 3pt hitch.
 

·
Registered
Joined
·
1,058 Posts
Discussion Starter #3
What is the height difference before and after when mounted on the 3pt hitch.
Can't mount it, it's two inches too long to hook up. Brackets add 6". Tip of cutting edge should be four inches off ground on level surface when I'm done.
 

·
Registered
Joined
·
3,873 Posts
Can't mount it, it's two inches too long to hook up. Brackets add 6". Tip of cutting edge should be four inches off ground on level surface when I'm done.
This is why I wish 3pt specs came with the measurement from the ground to the bottom pins so you would know if it would fit.A 1025r can lift a little higher than my x595 but not all cat 1 tractors are the same.Taller rear tires make a big difference in where the hitch sets when lowered and more of a total up and down stroke.I want to say my 3pt arms are 20-22" off the ground when raised.
 

·
Registered
Joined
·
1,058 Posts
Discussion Starter #5
image.jpeg

image.jpeg

image.jpeg

image.jpeg

Getting there! Going to mount it on the quick hitch tomorro and tac the top link clevis when the bushing fits nice in the hook. Will finish weld, dress up metal work and hopefully prime and shoot. Have to figure out a stand.
 

·
Premium Member
Joined
·
12,278 Posts
This is why I wish 3pt specs came with the measurement from the ground to the bottom pins so you would know if it would fit.
I know what you mean. Some manufacturers like Land Pride do provide specifications for the measurements on the mounting pins. It really helped me when comparing blades. I wish everyone provided this level of detail.

RB16-series.jpg
 

·
Registered
Joined
·
1,058 Posts
Discussion Starter #7
1 - 7 of 7 Posts
Top