Green Tractor Talk banner

Moding my subsoiler............ Maybe...........

2711 Views 11 Replies 5 Participants Last post by  jenkinsph
I have a KK subsoiler that I have been using. I think I have subsoiled about 4 acres at 14"s.

So, with the 4520, I am 71"s wide. That kind of sucks because I cannot get overly close paths without running over the center of the line I subsoiled.

So, I am thinking about making a wider chisel. The current chissel is about 2.5 inches wide. I am thinking about going to about 5 inches. It makes me wonder if I would stress the KK unit too much? I have zero issue with pulling it! I think I could pull 2, and maybe that would be the way to go.... But I would like to work with what I have for now.

Any thoughts?
1 - 2 of 2 Posts
Do you plan on running that with your 4520?

D.
Its hard to put too much money into this small equipment. We just won the bid on this multch ripper for the farm. So, I can just go there and grab it when needed. Its one of those things where its fun to play and mod stuff.

I found a chissel tooth at the farm that is 5.5 inches wide and not as thick as the current chissel. I am going to try to put it on in my spare time and mess with it. It might work, and it might not.

Here is the implement we bid on. Not bad for 5,100.00 We are so small its hard to buy new stuff.
I am talking about that 2700.

D.
Yes, so far i have zero issue pulling the current chissel as deep as I want. My fear is breaking the subsoiler...:lol:
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top