Looks good. What's the width? I have a Mongo tilt bucket for my KX121 that's 42". Do you have two aux hydraulic circuits so you can operate both the tilt and thumb at the same time? I have that on my KX080 and it makes operations much easier. My KX121 only has one aux circuit so I have to position manual diverter valves to select whether it operates the tilt or the thumb. Remotely controlled diverter valves would make it easier, but dual circuits is the best.

 

It is the 50”. I do have dual aux as I also run mulcher & a flail that has a place for the thumb to press against, so I needed duals.

 

That sounds great.

 

That's so awesome! Grading is going to be fun with that.

Do you have a picture of where the cylinders connect in the middle to pivot? Curious of the connection/geometry in there.

 

That's so awesome! Grading is going to be fun with that.

Do you have a picture of where the cylinders connect in the middle to pivot? Curious of the connection/geometry in there.

This is a great video that talks/shows the cylinders...

 

That is sweet, would love to have at the house for a couple weeks!

 

We have been able to get a few hours on the bucket, and it has been great. It is incredible how much better the right tool for the job works. I was torn between the 50" & the 60", but I was concerned that the 60" might be too much. In retrospect, I almost wish that I had gotten the 60" to have a bit more width to grade, but I am sure that there will be instances that I am glad that I have the 50.

 

That 306 can handle a 60” all day. You can also order a longer cutting edge and bolt that on your bucket or weld something that’ll bolt up to your bucket. And try to not jerk that thing around a lot or your pins will get sloppy. Nice Mongo. And nice 306