Green Tractor Talk banner

1 - 7 of 7 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I have a Gx325 and the motor dies when you Release the brake if you by pass the safety the motor runs till you start the pto have by passed all safety switch’s.
replaced the board and pto switch and motor will not run with deck on.
If you run a hot to deck Clutch will start on pto.
 

·
Registered
Joined
·
12,404 Posts
You have to unjumper the brake switch and then look at the seat switch.


You can’t jumper a brake switch, the computer logic must see brake on for some things, and brake off for others, like turning on the pto.
 

·
Registered
Joined
·
135 Posts
Sounds like the seat safety switch wires aren't getting a good connection somewhere in the harness. 👍🏻
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #4 ·
You have to unjumper the brake switch and then look at the seat switch.


You can’t jumper a brake switch, the computer logic must see brake on for some things, and brake off for others, like turning on the pto.
Ok but it won’t run with the safety it starts but went you let off the brake it dies
I have a Gx325 and the motor dies when you Release the brake if you by pass the safety the motor runs till you start the pto have by passed all safety switch’s.
replaced the board and pto switch and motor will not run with deck on.
If you run a hot to deck Clutch will start on pto.
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #5 ·
Ok,but it won’t run on the brake safety. Will start and if you hold the brake it will run
 

·
Registered
Joined
·
12,404 Posts
Ok but it won’t run with the safety it starts but went you let off the brake it dies
Correct, when the computer sees the brake off it must have the seat switch on or it kills the engine
 
1 - 7 of 7 Posts
Top