Green Tractor Talk banner
1 - 6 of 6 Posts

·
Registered
2019 1025r
Joined
·
5 Posts
Discussion Starter · #1 ·
Hi all, I need a hot switched ignition Lead for my wench. I have a 2018 1025r no mower deck. There’s a place for the mower lift switch lower left. Behind that hole is a connector plug I assume would be for the lift switch. Can I stab the red wire at that connector for a hot switched lead?
 

·
Super Moderator
Joined
·
4,137 Posts
Yes, but be aware that you'd only want to use that to trigger a relay. The wire doesn't have the ampacity to handle a typical winch.
 

·
Premium Member
Joined
·
2,791 Posts
Hi all, I need a hot switched ignition Lead for my wench. I have a 2018 1025r no mower deck. There’s a place for the mower lift switch lower left. Behind that hole is a connector plug I assume would be for the lift switch. Can I stab the red wire at that connector for a hot switched lead?
And does this wench have a name??
 

·
Premium Member
Joined
·
3,867 Posts
I used that connection to run my salt spreader. It is a switched power source. When the tractor switch is on its hot. My spreader uses a relay to switch the power from the battery.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top