Green Tractor Talk banner

1 - 4 of 4 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1
I recently bough a tiller whcih needed love, anyway it now goes onto my imatch and all is well. The last issue is the pto shaft coupler, its a old bushhog and it has a coupler that you need to pull back with balls, that lock on to the recess on the pto shaft. anyway there is plastic peace there and a spring, and it is broken. what to do ? replace the yoke, etC?
 

·
Administrator
Joined
·
18,802 Posts
Can you post a picture please? There are many different types of shafts and guards used on equipment.
 

·
Registered
Joined
·
226 Posts
Replacing the yoke is what I normally do, we have broken many of these type of PTO couplers over the years on our farms and found replacing the yoke ends up to be the best solutions do and it's not that costly
 

·
Registered
Joined
·
63 Posts
Agree with Red Badger... Should not be that hard or expensive to match new yoke to the u-joint, Quicker and easier.

TSC and other type of those stores usually have a good selection of that stuff.
 
1 - 4 of 4 Posts
Top