Green Tractor Talk banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I recently bought a L111 Pretty cheap she has some issues lol I just wanted the engine so I want to make sure it runs well before I do all the work of getting it out I can’t get it to do anything even with jumper pack on it I disabled the seat safety well there is no seat then I went to the brake switch and the switch itself is there and plugged in and here’s my issue the other end is up under the steering wheel yet I see nowhere to plug it into am I blind or just missing something
 

·
Registered
Joined
·
45 Posts
The two switches in the safety circuit that affect cranking are the brake switch and the PTO switch. The PTO switch is activated by the metal arm attached to the lever. If you are at wits end and really just going to test run this and yank the engine, you could either jump the solenoid at the large terminals or ground the safety line terminal at the solenoid. Should it not start, know that the carb solenoid needs to be powered and no ground at the coil.
 
1 - 2 of 2 Posts
Top