Green Tractor Talk banner

1 - 3 of 3 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
Good evening. I have a Z665 with a Briggs & Stratton 27hp motor. My stump gasket is leaking so I'm going to change it as well as all other gaskets and o-rings just to make sure I don't have to take the motor off again anytime soon. I'm going to change the o-ring behind the oil filter adapter but cannot find what the bolt should be torqued to. I have the technical repair manual but can't find it mentioned anywhere. Thank you for your help.
 

·
Registered
Joined
·
1,769 Posts
I just did one also. Could not find the torque either. Just use common sense and snug it up. You should be fine.

Sent from my LGL52VL using Tapatalk
 

·
Registered
Joined
·
12 Posts
Discussion Starter #3
Thanks for your reply. I was planning on using the same torque as the oil pump cover which is 50 lb.-in. since they both use similar o-rings.
 
1 - 3 of 3 Posts
Top