Green Tractor Talk banner

1 - 6 of 6 Posts

·
Registered
Joined
·
238 Posts
Discussion Starter #1
I've seen plenty of people on here like the ONMI Manufacturing Carry All and I'm thinking about ordering one for my 1025R, however I have a couple of questions that I haven't been able to figure out.

It looks like a lot of people have the carry all on a Transformer with or without weight rack and many with a quick hitch setup. I already have a cross draw bar on my 3-point so I was looking at getting the Heavy Duty Combo Draw Bar Trailer Hitch to use with the carry all. My concern is that it looks like all of the other hitches offset the middle of the carry all a few inches from the lower link arms. With the draw bar hitch the carry all would be centered directly over my draw bar and I'm concerned it is going to hit the toolbox.

Also I'm considering getting the version with both the vertical and horizontal mounting options so I could possibly use it on my vehicle or on the lower position of the combo hitch. My concern here is a again a matter of clearance. In the lower position using the horizontal mount, is the vertical mount doing to stick down too far and end up dragging on the ground when I have the 3-point down?
 

·
Premium Member
Joined
·
1,626 Posts
If you have your carry all "Level" then it will come close to the toolbox but it will clear. I put my FIMCO sprayer in it and spray my yard. When I ordered mine I didn't get the side screens and I wish I had. My Transformer is pretty awesome. It's on all the time.





-636
 

·
Registered
Joined
·
238 Posts
Discussion Starter #5
psrumors - I did email omni and he said the draw hitch would work, but wasn't sure about hitting the toolbox. He said to measure about 10 inches from the middle of the lower link arms. When I measured that it puts it right at the edge of the toolbox which is part of why I posted.

636mullet - Looking at your pictures I think that it would hit the toolbox with the draw bar hitch based on how tight yours looks with the transformer. I also see you got both the horizontal and vertical mounting options. Have you used the horizontal one? Have any issues with the vertical portion dragging in that configuration?
 

·
Premium Member
Joined
·
1,626 Posts
If you have your top link cranked all the way in I believe the CarryAll will hit the tool box. If it's leveled then it clears no problem. I haven't used the Horizontal mount other than one time to see how it looked. In uneven situations I could see the vertical post hitting, but with the CarryAll all the way up I don't see that to be much of an issue unless things are really steep. I'll try and snap some pictures tomorrow.

-636
 
1 - 6 of 6 Posts
Top