Green Tractor Talk banner

1 - 4 of 4 Posts

·
Registered
Joined
·
45 Posts
Discussion Starter #1
Over the last week I have been refitting my bush hog to work with my new QH on my 4105. The cutter with out the QH would rub the tires when lifted up. I built clevis from 1/2" flat bar for the top and lower pins. I made it 3" wide on the inside I'm using cat 1/2 and 2/3 bushings and washers so it could still be used with out a QH.
 

Attachments

·
Administrator
Joined
·
18,467 Posts
Nice job! That improvement will be appreciated for years to come!

My only comment is the you might need to brace those lower mounts a little better against the vertical flat bar, unless there's something there that I cant see in the picture.
 

·
Premium Member
Joined
·
1,706 Posts
Nice job! That improvement will be appreciated for years to come!

My only comment is the you might need to brace those lower mounts a little better against the vertical flat bar, unless there's something there that I cant see in the picture.

That was my first thought also. Add some small gussets on both sides behind the lower mounts.
 

·
Registered
Joined
·
45 Posts
Discussion Starter #4
The bracing was planed but overlooked. Y'all just saved me a big problem on down the road.
 
1 - 4 of 4 Posts
Top