Green Tractor Talk banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,109 Posts
Discussion Starter #1
Hey guys. Since I have had my Frontier RC2072 brush cutter, I noticed that my tractor doesn’t lift it very high. I realized that their are different height holes for the 3 point bushing pins to be located. I want to try the lower holes. The nut on the pin that the IMatch bushing goes on is larger than any socket I have. Anyone know it’s size?
 

·
Registered
Joined
·
1,109 Posts
Discussion Starter #2
My terminology is horrible. Sorry guys. I think they are called the lower hitch pins that’s installed on the Implement. Not the IMatch bushing that goes over it, but the pin itself. It is a 5 or 6 inch bolt with a big nut. Looking for that nut size.
 

·
Registered
Joined
·
1,833 Posts
My guess is pin is Cat ll 1-1/8 '' diameter with a 7/8'' nut that is 1.312 IN across flat to flat side
 

·
Registered
Joined
·
1,109 Posts
Discussion Starter #4
I bought an 1 ¼ inch socket, it is too small. Not by much, though. Going to try a 32 or 33 mm socket next.
 
1 - 4 of 4 Posts
Top