Green Tractor Talk banner

1 - 3 of 3 Posts

·
Registered
Joined
·
107 Posts
Discussion Starter #1 (Edited)
I will be selling a JD 47 snow thrower for a friend who had it mounted previously to a JD 425 tractor. On a earlier visit to the location of the 47 snow thrower, I had seen the snow thrower and a fairly long drive shaft. I did not see any smaller parts for the installation of the 47 snow thrower to the JD 425 tractor. Are there additional parts that should be removed from the JD 425 that should be included in the sale of the 47 snow thrower?

This JD 425 Tractor will still need to use the mower deck that is currently installed on the tractor.

Looking at JD parts online for the 425 tractor, I was not sure what is required for the installation of the 47 snow thrower to the JD 425 tractor.
Any help is appreciated.
Thanks
 

·
Registered
Joined
·
3,831 Posts
You'll need the quick hitch and there's a hanger on the front that the short blower shaft connects to one end and the long shaft connects to the other.
 

·
Registered
Joined
·
107 Posts
Discussion Starter #3
I did find the the front hanger (plate with bearing). I removed it with two bolts. Setup should now be complete.
Thank You.
 
1 - 3 of 3 Posts
Top