Green Tractor Talk banner

1 - 5 of 5 Posts

Registered
Joined
2 Posts
Discussion Starter #1
I'm replacing a concave on a jd 9600 it looks like it's bent??? the plate that you bolt on the front of it has 1/4 in space on both sides with putting a straight board on it you can see this. this is the third one I've gotten and the part house says it's right. A few friends that have replace concaves says that's not right. Has anyone else had this problem??? Look really close at the bottom of the board
 

Attachments

Registered
Joined
11,236 Posts
Are you sure that the board is square?
 

Registered
Joined
395 Posts
Is one of the bearings shot? Wish I could help more... we haven't run a walker combine in close to 15 years.
 
1 - 5 of 5 Posts
Top